vwrustylee@yahoo.com
07812 007 734
Custom, Hand-Crafted 'Rock & Roll' Campervan Beds

VW T4 / VW T5 VW Campervan Beds



3/4 WIDTH VW T4/T5 Campervan Beds

This is our 3/4 width bed for T4/T5 vans (will also fit other makes and models). The bed is made from 20x20x2.5mm, 50x25x2.5mm and 25x25x2.5mm box section and all the hinge plates are cnc laser cut. The bed sits over the wheel arch in the rear of front engined vans and fixes through the floor with high tensile bolts and spreader plates. The bed operates on heavy duty ball bearing slides so pulls from seat to bed position with ease, the front legs also sit 5mm higher than your floor so you don’t get any scuff marks on your nice new floor when pulling into bed position. The bed locks off into seat position with two heavy duty quick release spring loaded pins. It sits on rubber buffers, so no rattling when you’re on the move. The frame comes fully powder coated and operates from seat to bed mode in just a few seconds. This bed is designed to have the upholstery attached to the frame and not made with butt hinges like others out there, so your covers won’t go flying off when you have to brake hard.

  • Width 1090mm (custom widths and size available to order)
  • Length in bed position 1880mm
  • Fully powder coated in black (other colours available to order)
  • Designed to take 3 inch foam
  • Storage space underneath the bed

Prices

  • Bed (frame only) £350
  • Boards £50
  • Pair of seat belts £70
  • Gas strut £50

Shipping please contact us with your postcode for a quote

VW T5 Campervan Bed - Up Position

VW T5 Campervan Bed – Up Position

VW T5 Campervan Bed - Down Position

VW T5 Campervan Bed – Down Position

Campervan Picture from Base Campers




FULL WIDTH VW T4/T5 Campervan Beds

This is our full width bed for T4/T5 vans (will also fit other makes and models). The bed is made from 20x20x2.5mm, 50x25x2.5mm and 25x25x2.5mm box section and all the hinge plates are cnc laser cut. The bed sits over the wheel arches in the rear of front engined vans and fixes through the floor with high tensile bolts and spreader plates. The bed operates on heavy duty ball bearing slides so pulls from seat to bed position with ease, the front legs also sit 5mm higher than your floor so you don’t get any scuff marks on your nice new floor when pulling into bed position.  The bed locks off into seat position with two heavy duty quick release spring loaded pins. It sits on rubber buffers, so no rattling when you’re on the move. The frame comes fully powder coated and operates from seat to bed mode in just a few seconds. This bed is designed to have the upholstery attached to the frame and not made with butt hinges like others out there, so your covers won’t go flying off when you have to brake hard.

  • Width 1470mm (custom widths and size available to order)
  • Length in bed position 1880mm
  • Fully powder coated in black (other colours available to order)
  • Designed to take 3 inch foam
  • Storage space underneath the bed

Prices

  • Bed (frame only) £400
  • Boards £60
  • Pair of seat belts £70
  • Gas strut £50

Shipping please contact us with your postcode for a quote.